91. The ac voltage gain of a Darlington connection is about ________.
(a) 0
(b) 1
(c) D
(d) None of the above
92. In an emitter-follower, the output voltage is ________ with the input voltage.
(a) 45º out of phase
(b) 90º out of phase
(c) 180º out of phase
(d) in phase
93. A common-base configuration has ________ impedance at the input and ________ impedance at the output.
(a) high, high
(b) high, low
(c) low, low
(d) low, high
94. An emitter-follower has ________ impedance at the input and ________ impedance at the output.
(a) high, high
(b) low, high
(c) high, low
(d) low, low
95. ________ is slightly affected if the condition ro 10RE is not satisfied in the analysis of an emitter-follower configuration.
(a) Zi
(b) Zo
(c) Av
(d) Ai
Related Posts
BJT Amplifiers » Exercise - 1 1. Nota 2. The dc emitter current of a transistor is 8 mA. What is the value of re? (a) 320 (b) 13.3 k (c) 3.125 (d) 5.75 3. What is the most important r parameter for amplifier analysis? (a) rb (b) rc (c) (d) 4. Which of the h-parameters corresponds to re in a common-base configuration? (a) hib (b) hfb (c) hrb (d) hob 5. Under which of the following conditions is the output impedance of the network approximately equal to RC for a common-emitter fixed-bias configuration? (a) ro 10RC (b) ro 2 10RC (c) ro 2 ro (d) ro 4 ro 6. What is the unit of the parameter ho? (a) Volt (b) Ohm (c) Siemen (d) No unit 7. Which of the following gains is less than 1 for a common-base configuration? (a) Ai (b) Av (c) Ap (d) None of the above 8. Which of the following configurations has the lowest output impedance? (a) Fixed-bias (b) Voltage-divider (c) Emitter-follower (d) None of the above 9. Which one of the following configurations has the lowest input impedance? (a) Fixed-bias (b) Common-base (c) Emitter-follower (d) Voltage-divider? 10. The current gain for the Darlington…