BJT Amplifiers » Exercise – 2
51. What is the typical value of the current gain of a common-base configuration?
(a) Less than 1
(b) Between 1 and 50
(c) Between 100 and 200
(d) Undefined
52. What is the controlling current in a common-base configuration?
(a) Ie
(b) Ic
(c) Ib
(d) None of the above
53. What is the range of the input impedance of a common-base configuration?
(a) A few ohms to a maximum of 50
(b) 1 k to 5 k
(c) 100 k to 500 k
(d) 1 M to 2 M
54. Under which of the following condition(s) is the current gain ?
(a) ro 10RC
(b) RB 10re
(c) ro 10RC and RB 10re
(d) None of the above
55. What is the typical range of the output impedance of a common-emitter configuration?
(a) 10 to 100
(b) 1 k to 5 k
(c) 40 k to 50 k
(d) 500 k to 1 k
Related Posts
BJT Amplifiers » Exercise - 1 1. Nota 2. The dc emitter current of a transistor is 8 mA. What is the value of re? (a) 320 (b) 13.3 k (c) 3.125 (d) 5.75 3. What is the most important r parameter for amplifier analysis? (a) rb (b) rc (c) (d) 4. Which of the h-parameters corresponds to re in a common-base configuration? (a) hib (b) hfb (c) hrb (d) hob 5. Under which of the following conditions is the output impedance of the network approximately equal to RC for a common-emitter fixed-bias configuration? (a) ro 10RC (b) ro 2 10RC (c) ro 2 ro (d) ro 4 ro 6. What is the unit of the parameter ho? (a) Volt (b) Ohm (c) Siemen (d) No unit 7. Which of the following gains is less than 1 for a common-base configuration? (a) Ai (b) Av (c) Ap (d) None of the above 8. Which of the following configurations has the lowest output impedance? (a) Fixed-bias (b) Voltage-divider (c) Emitter-follower (d) None of the above 9. Which one of the following configurations has the lowest input impedance? (a) Fixed-bias (b) Common-base (c) Emitter-follower (d) Voltage-divider? 10. The current gain for the Darlington…