5555555555
57. In the operation of two 311 voltage comparators as the voltage window detector, a low output indicates that the input is ________.
(a) above the higher reference voltage
(b) below the lower reference voltage
(c) either above the higher reference voltage or below the lower reference voltage
(d) within the high and the low reference voltages
| Subject Name : Electronics Engineering |
| Exam Name : IIT GATE, UPSC ESE, RRB, SSC, DMRC, NMRC, BSNL, DRDO, ISRO, BARC, NIELIT |
| Posts Name : Assistant Engineer, Management Trainee, Junior Engineer, Technical Assistant |
| Electronics & Communication Engineering Books
|
| GATE 2023 Total Info | ENGG DIPLOMA | UGC NET Total Info |
| IES 2023 Total Info | PSUs 2022 Total Info | CSIR UGC NET Total Info |
| JAM 2023 Total Info | M TECH 2023 Total Info | RAILWAY 2022 Total Info |
Related Posts
555555555555. In the operation of two 311 voltage comparators as the voltage window detector, a high output indicates that the input is ________. (a) above the higher reference voltage (b) below the lower reference voltage (c) either above the higher reference voltage or below the lower reference voltage (d) within the high and the low reference voltages- 5555555555 1. In a comparator, the level of the reference voltage must be ________. (a) negative (b) positive (c) zero (d) All of the above
- Linear Digital ICs » Exercise - 2 51. The conversion resolution of an 8-stage counter operating an 8-stage ladder network using a reference voltage of 5 V is ________. (a) 0.0195 mV (b) 0.195 mV (c) 1.95 mV (d) 19.5 mV 52. A phase-locked loop (PLL) is an electronic circuit that consists of ________. (a) a phase detector (b) a low-pass filter (c) a voltage-controlled oscillator (d) All of the above 53. In the frequency-shift keyed (FSK) signal decoder, the RC ladder filter is used to ________. (a) remove the difference frequency component (b) remove the sum frequency component (c) remove both the difference and the sum frequency components (d) None of the above 54. Time periods for monostable operation of the 555 timer can range from ________ to ________, making this IC useful for a range of applications. (a) picoseconds, nanoseconds (b) nanoseconds, milliseconds (c) microseconds, many seconds (d) None of the above 55. In the operation of two 311 voltage comparators as the voltage window detector, a high output indicates that the input is ________. (a) above the higher reference voltage (b) below the lower reference voltage (c) either above the higher reference voltage or below the lower reference…
- Regulated Power Supplies » Exercise - 3 101. In a simple series regulator circuit, which of the following components is the controlling element? (a) Load resistor (b) Zener diode (c) Transistor Q1 (d) None of the above 102. What regulated output voltage is provided for the following circuit elements: R1 = 15 kΩ, R2 = 35 kΩ, and VZ = 11.2 V? (a) 16.50 V (b) 17 V (c) 17.35 V (d) 18.25 V 103. Nota 104. Which component(s) set(s) the voltage across the load in a basic transistor shunt regulator? (a) Zener diode (b) Transistor base-emitter voltage (c) Both the Zener diode and the transistor base-emitter voltage (d) None of the above 105. In a full-wave rectifier, if no load were connected across the capacitor, the output voltage would ideally be a(n) ________. (a) ac voltage (b) constant dc voltage (c) pulsating dc voltage (d) ramp voltage 106. The output of a loaded power supply is ________ that of the unloaded. (a) the same as (b) larger than (c) smaller than (d) None of the above 107. The frequency of the output voltage of a full-wave rectifier is ________ the frequency of its input voltage. (a) the same as (b)…
- 555555555546. An input at a frequency of 1070 Hz will drive the decoder output voltage to ________. (a) –5 V (b) 14 V (c) –5 V and 14 V (d) None of the above