5555555555
24. Which operation class is generally used in radio or communications?
(a) A
(b) B
(c) AB
(d) C
| Subject Name : Electronics Engineering |
| Exam Name : IIT GATE, UPSC ESE, RRB, SSC, DMRC, NMRC, BSNL, DRDO, ISRO, BARC, NIELIT |
| Posts Name : Assistant Engineer, Management Trainee, Junior Engineer, Technical Assistant |
| Electronics & Communication Engineering Books
|
| GATE 2023 Total Info | ENGG DIPLOMA | UGC NET Total Info |
| IES 2023 Total Info | PSUs 2022 Total Info | CSIR UGC NET Total Info |
| JAM 2023 Total Info | M TECH 2023 Total Info | RAILWAY 2022 Total Info |
Related Posts
555555555577. Which of the following is (are) power amplifiers? (a) Class A (b) Class B or AB (c) Class C or D (d) All of the above- 555555555535. The Q-point is at cutoff for class ________ operation. (a) A (b) B (c) C (d) AB
- 555555555519. ________ amplifiers have the highest overall efficiency. (a) Class A (b) Class B or AB (c) Class C (d) Class D
- 555555555518. Class D operation can achieve power efficiency of over ________. (a) 90% (b) 78.5% (c) 50% (d) 25%
- Electronics Engineering » Notes » Single Stage Transistor Amplifiers 1. There are four classes of amplifier operations : Class A, Class AB, Class B, and Class C. 2. Class A amplifiers operate entirely in the active region and thus the output if a faithful reproduction of the input signal with some amplification. In a Class A amplifier the efficiency is very low. Class A amplifiers are usedfor audio and frequency amplification. 3. Class AB amplifiers are biased so that the collector current is cutoff for a portion of one cycle of the input and so the efficiency is higher than that of a Class A amplifier. Class AB amplifiers are normally used as push−pull amplifiers to alleviate the crossover distortion of Class B amplifiers. 4. Class B amplifiers are biased so that the collector current is cutoff during one−half of the input signal. Therefore, the efficiency in a Class B amplifier is higher than that of a Class AB amplifier. Class B amplifiers are used in amplifiers requiring high power output. 5. Class C amplifiers are biased so that the collector current flows for less than one−half cycle of the input signal. Class C amplifiers have the highest efficiency and are used for radio frequency amplification in transmitters. Figure-1 :…