36. Ten TTL loads per TTL driver is known as:
(a) noise immunity
(b) fan-out
(c) power dissipation
(d) propagation delay
37. If all inputs to a TTL NAND gate are low, what is the ON, OFF condition of each transistor in the circuit?
(a) Q1-ON, Q2-OFF, Q3-ON, Q4-OFF
(b) Q1-ON, Q2-ON, Q3-OFF, Q4-OFF
(c) Q1-OFF, Q2-OFF, Q3-ON, Q4-ON
(d) Q1-OFF, Q2-ON, Q3-OFF, Q4-ON
38. The output current capability of a single 7400 NAND gate when HIGH is called ________.
(a) source current
(b) sink current
(c) IOH
(d) source current of IOH
39. The most common TTL series ICs are:
(a) E-MOSFET
(b) 7400
(c) quad
(d) AC00
40. What is the difference between the 54XX and 74XX series of TTL logic gates?
(a) 54XX is faster.
(b) 54XX is slower.
(c) 54XX has a wider power supply and expanded temperature range.
(d) 54XX has a narrower power supply and contracted temperature range.
Related Posts
555555555575. A major advantage of ECL logic over TTL and CMOS is ________. (a) low power dissipation (b) high speed (c) both low power dissipation and high speed (d) neither low power dissipation nor high speed- 555555555510. Which of the following summarizes the important features of emitter-coupled logic (ECL)? (a) low noise margin, low output voltage swing, negative voltage operation, fast, and high power consumption (b) good noise immunity, negative logic, high-frequency capability, low power dissipation, and short propagation time (c) low propagation time, high-frequency response, low power consumption, and high output voltage swings (d) poor noise immunity, positive supply voltage operation, good low-frequency operation, and low power
- 555555555568. Which of the following summarizes the important features of ECL? (a) Low noise margin, low output voltage swing, negative voltage operation, fast, and high power consumption (b) Good noise immunity, negative logic, high frequency capability, low power dissipation, and short propagation time (c) Slow propagation time, high frequency response, low power consumption, and high output voltage swings (d) Poor noise immunity, positive supply voltage operation, good low frequency operation, and low power
- 555555555518. Why is a pull-up resistor needed when connecting TTL logic to CMOS logic? (a) to increase the output LOW voltage (b) to decrease the output LOW voltage (c) to increase the output HIGH voltage (d) to decrease the output HIGH voltage
- 5555555555130. A certain gate draws 1.8 A when its output is HIGH and 3.3 µA when its output is LOW. VCC is 5 V and the gate is operated on a 50% duty cycle. What is the average power dissipation (PD)? (a) 2.55 W (b) 1.27 W (c) 12.75 W (d) 5 W