5555555555
31. Totem-pole outputs ________ be connected ________ because ________.
(a) can, in parallel, sometimes higher current is required
(b) cannot, together, if the outputs are in opposite states excessively high currents can damage one or both devices
(c) should, in series, certain applications may require higher output voltage
(d) can, together, together they can handle larger load currents and higher output voltages
| Subject Name : Electronics Engineering |
| Exam Name : IIT GATE, UPSC ESE, RRB, SSC, DMRC, NMRC, BSNL, DRDO, ISRO, BARC, NIELIT |
| Posts Name : Assistant Engineer, Management Trainee, Junior Engineer, Technical Assistant |
| Electronics & Communication Engineering Books
|
| GATE 2023 Total Info | ENGG DIPLOMA | UGC NET Total Info |
| IES 2023 Total Info | PSUs 2022 Total Info | CSIR UGC NET Total Info |
| JAM 2023 Total Info | M TECH 2023 Total Info | RAILWAY 2022 Total Info |
Related Posts
5555555555102. Totem-pole outputs ________ be connected ________ because ________. (a) can, in parallel, sometimes higher output current is required (b) cannot, together, if the outputs are in opposite states excessively high currents can damage one or both of the devices (c) should, in series, certain applications may require higher output voltage (d) can, together, together they can handle larger load currents and higher output voltages- Regulated Power Supplies » Exercise - 3 101. In a simple series regulator circuit, which of the following components is the controlling element? (a) Load resistor (b) Zener diode (c) Transistor Q1 (d) None of the above 102. What regulated output voltage is provided for the following circuit elements: R1 = 15 kΩ, R2 = 35 kΩ, and VZ = 11.2 V? (a) 16.50 V (b) 17 V (c) 17.35 V (d) 18.25 V 103. Nota 104. Which component(s) set(s) the voltage across the load in a basic transistor shunt regulator? (a) Zener diode (b) Transistor base-emitter voltage (c) Both the Zener diode and the transistor base-emitter voltage (d) None of the above 105. In a full-wave rectifier, if no load were connected across the capacitor, the output voltage would ideally be a(n) ________. (a) ac voltage (b) constant dc voltage (c) pulsating dc voltage (d) ramp voltage 106. The output of a loaded power supply is ________ that of the unloaded. (a) the same as (b) larger than (c) smaller than (d) None of the above 107. The frequency of the output voltage of a full-wave rectifier is ________ the frequency of its input voltage. (a) the same as (b)…
- 5555555555104. The HIGH logic level for a standard TTL output must be at least ________. (a) 2.4 V (b) 2 V (c) 0.8 V (d) 5 V
- 555555555538. The output of this circuit is always ________. (a) 1 (b) 0 (c) A (d) A
- 555555555539. The output of this circuit is always ________. (a) 1 (b) 0 (c) A (d) A