5555555555
50. The same signal in Problem 2 is applied to an RC high-pass filter. If the reactance is zero at the input frequency, the output voltage is
(a) 18 V peak-to-peak
(b) zero
(c) 9 V peak-to-peak
(d) 12.73 V peak-to-peak
| Subject Name : Electronics Engineering |
| Exam Name : IIT GATE, UPSC ESE, RRB, SSC, DMRC, NMRC, BSNL, DRDO, ISRO, BARC, NIELIT |
| Posts Name : Assistant Engineer, Management Trainee, Junior Engineer, Technical Assistant |
| Electronics & Communication Engineering Books
|
| GATE 2023 Total Info | ENGG DIPLOMA | UGC NET Total Info |
| IES 2023 Total Info | PSUs 2022 Total Info | CSIR UGC NET Total Info |
| JAM 2023 Total Info | M TECH 2023 Total Info | RAILWAY 2022 Total Info |
Related Posts
5555555555 51. A sinusoidal voltage with a peak-to-peak value of 18 V is applied to an RC low-pass filter. If the reactance at the input frequency is zero, the output voltage is ________. (a) 18 V peak-to-peak (b) zero (c) 9 V peak-to-peak (d) 12.74 V peak-to-peak- 5555555555 46. The maximum output voltage of a certain low-pass filter is 15 V. The output voltage at the critical frequency is ________. (a) 0 V (b) 15 V (c) 10.60 V (d) 21.21 V
- 5555555555 59. At a certain frequency, the output voltage of a filter is 6 V and the input is 12 V. The voltage ratio in decibels is ________. (a) 6.02 dB (b) –6.02 dB (c) 12.04 dB (d) –12.04 dB
- Regulated Power Supplies » Exercise - 3 101. In a simple series regulator circuit, which of the following components is the controlling element? (a) Load resistor (b) Zener diode (c) Transistor Q1 (d) None of the above 102. What regulated output voltage is provided for the following circuit elements: R1 = 15 kΩ, R2 = 35 kΩ, and VZ = 11.2 V? (a) 16.50 V (b) 17 V (c) 17.35 V (d) 18.25 V 103. Nota 104. Which component(s) set(s) the voltage across the load in a basic transistor shunt regulator? (a) Zener diode (b) Transistor base-emitter voltage (c) Both the Zener diode and the transistor base-emitter voltage (d) None of the above 105. In a full-wave rectifier, if no load were connected across the capacitor, the output voltage would ideally be a(n) ________. (a) ac voltage (b) constant dc voltage (c) pulsating dc voltage (d) ramp voltage 106. The output of a loaded power supply is ________ that of the unloaded. (a) the same as (b) larger than (c) smaller than (d) None of the above 107. The frequency of the output voltage of a full-wave rectifier is ________ the frequency of its input voltage. (a) the same as (b)…
- 5555555555 27. Identify the frequency response curve for a high-pass filter. (a) a (b) b (c) c (d) d