119. In order to check the CLR function of a counter, ________.
(a) apply the active level to the CLR input and check all of the Q outputs to see if they are all in their reset state (b) ground the CLR input and check to be sure that all of the Q outputs are LOW (c) connect the CLR input to Vcc and check to see if all of the Q outputs are HIGH (d) connect the CLR to its correct active level while clocking the counter; check to make sure that all of the Q outputs are toggling
Answer
Answer : (a)
Explanation
Explanation : No answer description available for this question. Let us discuss.
Counters » Exercise - 1 1. The purpose of introducing feedback loop in digital counter circuit is : (a) To improve distortion (b) To improve stability (c) Synchronise input and output pulses (d) to reduce the number of input pulses to reset the counter 2. The circuit shown below is a : (a) Mod-4 counter (b) Mod-5 counter (c) Mod-6 counter (d) Mod-7 counter 3. In this type of counter, the output of the last stage is connected to the D input of the first stage. (a) Ring Counter (b) Johnson Counter (c) Straight Counter (d) None of the above 4. A counter is a : (a) Sequential circuit (b) Combinational circuit (c) Both combinational and sequential circuit (d) None of above 5. A counter with 10 states : (a) Cascading asynchronous counter (b) Decade counter (c) Asynchronous ripple counter (d) Ripple counter 6. In this type of counter, the complement of the output of the last stage of the shift register is fed back to the D input of the first state. (a) Ring Counter (b) Johnson Counter (c) Straight Counter (d) None of the above 7. It is a sequential circuit that cycles through a sequence of states : (a) Multiplexer (b) Demultiplexer (c) Counter…
555555555553. For the device shown here, assume the D input is LOW, both S inputs are HIGH, and the input is HIGH. What is the status of the outputs? (a) All are HIGH. (b) All are LOW. (c) All but are LOW. (d) All but are HIGH.
5555555555253. What is the function of an enable input on a multiplexer chip? (a) to apply Vcc (b) to connect ground (c) to active the entire chip (d) to active one half of the chip
Counters » Exercise - 1 1. The purpose of introducing feedback loop in digital counter circuit is : (a) To improve distortion (b) To improve stability (c) Synchronise input and output pulses (d) to reduce the number of input pulses to reset the counter 2. The circuit shown below is a : (a) Mod-4 counter (b) Mod-5 counter (c) Mod-6 counter (d) Mod-7 counter 3. In this type of counter, the output of the last stage is connected to the D input of the first stage. (a) Ring Counter (b) Johnson Counter (c) Straight Counter (d) None of the above 4. A counter is a : (a) Sequential circuit (b) Combinational circuit (c) Both combinational and sequential circuit (d) None of above 5. A counter with 10 states : (a) Cascading asynchronous counter (b) Decade counter (c) Asynchronous ripple counter (d) Ripple counter 6. In this type of counter, the complement of the output of the last stage of the shift register is fed back to the D input of the first state. (a) Ring Counter (b) Johnson Counter (c) Straight Counter (d) None of the above 7. It is a sequential circuit that cycles through a sequence of states : (a) Multiplexer (b) Demultiplexer (c) Counter…