5555555555
6. The voltage gain of a basic instrumentation amplifier is set by a(n)
(a) diode.
(b) capacitor.
(c) resistor.
(d) inductor.
| Subject Name : Electronics Engineering |
| Exam Name : IIT GATE, UPSC ESE, RRB, SSC, DMRC, NMRC, BSNL, DRDO, ISRO, BARC, NIELIT |
| Posts Name : Assistant Engineer, Management Trainee, Junior Engineer, Technical Assistant |
| Electronics & Communication Engineering Books |
| GATE 2023 Total Info | ENGG DIPLOMA | UGC NET Total Info |
| IES 2023 Total Info | PSUs 2022 Total Info | CSIR UGC NET Total Info |
| JAM 2023 Total Info | M TECH 2023 Total Info | RAILWAY 2022 Total Info |
Related Posts
555555555531. Refer the given circuits. Which circuit is known as an OTA? (a) a (b) b (c) c (d) d- 5555555555 7. A(n) ________ is not a component of a passive filter. (a) op-amp (b) capacitor (c) inductor (d) resistor
- Special Diodes » Exercise - 1 1. A Zener diode : (a) Is a battery under forward biased condition (b) Acts like battery when it breakdowns (c) Is a switch (d) Is a device having barrier potential more than 5V 2. At 25ºC, a Zener diode rates at 2 watts, its power rating at 50ºC will be : (a) Zero watts (b) Less than 1 watt (c) Greater than 2 watts (d) Less than 2 watts 3. Silicon is appreciably employed as a base material compared to germanium while manufacturing Zener diode since : (a) silicon is abundantly available (b) it is costlier (c) it has low current capability (d) it has high temperature capability 4. The capacitance of a varactor diode increases, when the reverse voltage across it is : (a) Decreased (b) Increased (c) Kept constant (d) None of the above 5. The main advantage of a point contact diode is that : (a) The ratio of forward current to reverse current is very high (b) Low input impedance (c) Its cut-in voltage is equal to zero (d) Its reverse resistance is infinite 6. Which one of the following is a Square law device ? (a) Zener diode (b) Crystal diode (c) Tunnel diode (d) Varactor diode 7. Match the given lists. List I…
- 555555555550. The external resistor of a typical instrumentation amplifier is used to set the ________. (a) impedance (b) rejection ratio (c) gain (d) isolation
- 555555555547. The voltage gain of an OTA can be calculated using the formula (a) (b) (c) (d)