161. If a noninverting amplifier has an RIN of 1000 ohms and an RFB of 2.5 kilohms, what is the RIN voltage when 1.42 mV is applied to the correct input?
(a) 3.5 mV
(b) ground
(c) 1.42 mV
(d) 0.56 mV
162. If ground is applied to the (+) terminal of an inverting op-amp, the (–) terminal will:
(a) not need an input resistor
(b) be virtual ground
(c) have high reverse current
(d) not invert the signal
163. What is the frequency of this 555 astable multivibrator?
(a) 278 Hz
(b) 178 Hz
(c) 78 Hz
(d) 8 Hz
164. How many logic states does an S-R flip-flop have?
(a) 2
(b) 3
(c) 4
(d) 5
165. What is the output waveform?
(a) sine wave
(b) square wave
(c) +15 V
(d) –15 V
Related Posts
Operational Amplifier Fundamentals » Exercise - 3 101. An operational amplifier has a ________ input impedance and a ________ output impedance. (a) high, low (b) high, high (c) low, low (d) low, high 102. What is the difference voltage if the inputs are an ideal opposite signal? (a) The differential gain times twice the input signal. (b) The differential gain times the input signal. (c) The common-mode gain times twice the input signal. (d) The common-mode gain times the input signal. 103. At what input voltage level does the output voltage level become numerically equal to the value of the common-mode gain of the amplifier? (a) Vi1 = –Vi2 = 0.25 V (b) Vi1 = –Vi2 = 0.50 V (c) Vi1 = –Vi2 = 0.75 V (d) Vi1 = –Vi2 = 1.00 V 104. What is the difference output voltage of any signals applied to the input terminals? (a) The differential gain times the difference input voltage. (b) The common-mode gain times the common input voltage. (c) The sum of the differential gain times the difference input voltage and the common-mode gain times the common input voltage. (d) The difference of the differential gain times the difference input voltage and the common-mode gain times the common input voltage. 105.…
555555555580. Which of the following is (are) the result of gain reduction by a feedback? (a) The amplifier voltage gain is a more stable and precise value. (b) The input impedance of the circuit is increased over that of the op-amp alone. (c) The output impedance is reduced over that of the op-amp alone. (d) All of the above