5555555555
53. Which of the following will not normally be found on a data sheet?
(a) Minimum HIGH level output voltage
(b) Maximum LOW level output voltage
(c) Minimum LOW level output voltage
(d) Maximum HIGH level input current
| Subject Name : Electronics Engineering |
| Exam Name : IIT GATE, UPSC ESE, RRB, SSC, DMRC, NMRC, BSNL, DRDO, ISRO, BARC, NIELIT |
| Posts Name : Assistant Engineer, Management Trainee, Junior Engineer, Technical Assistant |
| Electronics & Communication Engineering Books |
| GATE 2023 Total Info | ENGG DIPLOMA | UGC NET Total Info |
| IES 2023 Total Info | PSUs 2022 Total Info | CSIR UGC NET Total Info |
| JAM 2023 Total Info | M TECH 2023 Total Info | RAILWAY 2022 Total Info |
Related Posts
5555555555104. The HIGH logic level for a standard TTL output must be at least ________. (a) 2.4 V (b) 2 V (c) 0.8 V (d) 5 V- 5555555555174. A NOR gate with one HIGH input and one LOW input: (a) will output a HIGH (b) functions as an AND (c) will not function (d) will output a LOW
- 555555555559. The minimum input voltage recognized as HIGH by a TTL gate is ________. (a) 2.0 V (b) 2.4 V (c) 0.8 V (d) 5.0 V
- Logic Families » Exercise - 1 4. Positive logic in a logic circuit is one in which : (a) Logic 0 and 1 are represented by 0 and positive voltage respectively (b) Logic 0 and, -1 are represented by negative and positive voltages respectively (c) Logic 0 voltage level is higher than logic 1 voltage level (d) Logic 0 voltage level is lower than logic 1 voltage level
- Regulated Power Supplies » Exercise - 3 101. In a simple series regulator circuit, which of the following components is the controlling element? (a) Load resistor (b) Zener diode (c) Transistor Q1 (d) None of the above 102. What regulated output voltage is provided for the following circuit elements: R1 = 15 kΩ, R2 = 35 kΩ, and VZ = 11.2 V? (a) 16.50 V (b) 17 V (c) 17.35 V (d) 18.25 V 103. Nota 104. Which component(s) set(s) the voltage across the load in a basic transistor shunt regulator? (a) Zener diode (b) Transistor base-emitter voltage (c) Both the Zener diode and the transistor base-emitter voltage (d) None of the above 105. In a full-wave rectifier, if no load were connected across the capacitor, the output voltage would ideally be a(n) ________. (a) ac voltage (b) constant dc voltage (c) pulsating dc voltage (d) ramp voltage 106. The output of a loaded power supply is ________ that of the unloaded. (a) the same as (b) larger than (c) smaller than (d) None of the above 107. The frequency of the output voltage of a full-wave rectifier is ________ the frequency of its input voltage. (a) the same as (b)…