Oscillators » Exercise – 1
1. For generating 1 kHz signal, the most suitable circuit is :
(a) colpitts oscillator
(b) hartley oscillator
(c) tuned collector oscillator
(d) wien bridge oscillator
2. The feedback factor β at the frequency of oscillation of a Wien bridge oscillator is :
(a) 3
(b) 1/3
(c) 1/29
(d) 3/29
3. The use of crystal in a tunable oscillator :
(a) improves frequency stability
(b) increases the gain of the oscillator
(c) helps to obtain optimum output impedance
(d) facilitates generation of wide range of frequencies
4. A phase shift oscillator uses :
(a) LC tuning
(b) piezoelectric crystal
(c) balanced bridge
(d) variable frequency operation
5. A highly stable resonance characteristic is the property of a …….. oscillator.
(a) hartley
(b) colpitts
(c) crystal
(d) wein bridge
Related Posts
5555555555 80. In the IC phase-shift oscillator, what should the ratio of feedback resistor Rf to R1 be? (a) Zero (b) Greater than –29 (c) Less than 29 (d) Any value- 555555555520. What is the total phase shift requirement, around the feedback loop, for a phase-shift oscillator? (a) 90° (b) 180° (c) 270° (d) 360°
- 5555555555 36. In order to start up, a feedback oscillator requires ________. (a) negative feedback less than 1. (b) positive feedback greater than 1. (c) unity feedback equal to 1. (d) no feedback.
- 5555555555 58. The attenuation of the three-section RC feedback phase-shift oscillator is ________. (a) 1/9. (b) 1/30. (c) 1/3. (d) 1/29.
- 5555555555 59. The feedback signal in a(n) ________ oscillator is derived from an inductive voltage divider in the LC circuit. (a) Hartley (b) Armstrong (c) Colpitts (d) Any of these