6. The generic array logic (GAL) device is ________.
(a) one-time programmable
(b) reprogrammable
(c) a CMOS device
(d) reprogrammable and a CMOS device
7. Any number with an exponent of zero is equal to:
(a) zero
(b) one
(c) that number
(d) ten
8. Which of the following statements does NOT describe an advantage of digital technology?
(a) The values may vary over a continuous range.
(b) The circuits are less affected by noise.
(c) The operation can be programmed.
(d) Information storage is easy.
9. In the decimal numbering system, what is the MSD?
(a) The middle digit of a stream of numbers
(b) The digit to the right of the decimal point
(c) The last digit on the right
(d) The digit with the most weight
10. The range of voltages between VL(max) and VH(min) are ________.
(a) unknown
(b) unnecessary
(c) unacceptable
(d) between 2 V and 5 V
Related Posts
Introduction to Digital Systems » Exercise - 13. Digital systems represent quantities : (a) using more bits in its binary codes as the quantity value increases. (b) using more bits in its binary code as more accuracy is required. (c) using binary codes with just two levels – 1 or 0, high level or low level. (d) all of the above.- Introduction to Digital Systems » Exercise - 12. Analog signals : (a) vary smoothly, then change abruptly to new values. (b) consist of codes of high-level and low-level signals. (c) vary smoothly continuously. (d) have periods of high-level and low-level signals, then change to continuous signals.
- 555555555516. A demultiplexer has ________. (a) one data input and a number of selection inputs, and they have several outputs (b) one input and one output (c) several inputs and several outputs (d) several inputs and one output
- 555555555511. The output of an AND gate is LOW ________. (a) all the time (b) when any input is LOW (c) when any input is HIGH (d) when all inputs are HIGH
- 555555555512. The output of an OR gate is LOW when ________. (a) all inputs are LOW (b) any input is LOW (c) any input is HIGH (d) all inputs are HIGH