FET – Exercise – 1

31. The transconductance JFET at the Q-point is ……… the maximum transconductance which occurs when Vds = 0.

(a) Less than
(b) Greater than
(c) Equal to
(d) None of the above

Answer
Answer : (a)
Explanation
Explanation : No answer description available for this question. Let us discuss.
Discuss
Discuss : Write your answer. Click here.

32. A current regulator diode is basically a :

(a) Zener diode
(b) MOSFET
(c) JFET whose gate and source are tied up
(d) Transistor

Answer
Answer : (c)
Explanation
Explanation : No answer description available for this question. Let us discuss.
Discuss
Discuss : Write your answer. Click here.

33. A JFET has :

(a) One built-in diode
(b) Two built-in diodes
(c) Three built-in diodes
(d) Four built-in diodes

Answer
Answer : (b)
Explanation
Explanation : No answer description available for this question. Let us discuss.
Discuss
Discuss : Write your answer. Click here.

34. The JFET acts as a …….. along the horizontal part of the drain curve.

(a) Resistor
(b) Current source
(c) Voltage source
(d) Current sink

Answer
Answer : (b)
Explanation
Explanation : No answer description available for this question. Let us discuss.
Discuss
Discuss : Write your answer. Click here.

35. Which of the following is/are valid statement(s) ?
I. The gate of a JFET is forward biased hence acts as a voltage controlled device.
II. The gate of a JFET is reversed biased, hence acts as a voltage controlled device.
III. The gate of a JFET is reverse biased, hence acts as voltage controlled device.

(a) I
(b) II
(c) I and II
(d) I, II and III

Answer
Answer : (b)
Explanation
Explanation : No answer description available for this question. Let us discuss.
Discuss
Discuss : Write your answer. Click here.

Related Posts

  • FET - 50FET » Exercise - 150. The input control parameter of a JFET is ....... (a) gate voltage (b) source voltage (c) drain voltage (d) gate current
    Tags: voltage, gate, fet, input, jfet, source, drain, current, electronics, engineering
  • FET - Exercise - 2FET » Exercise - 2 51. A common base configuration of a pnp transistor is analogous to ....... of a JFET. (a) common source configuration (b) common drain configuration (c) common gate configuration (d) none of the above 52. A JFET has high input impedance because ....... (a) it is made of semiconductor material (b) input is reverse biased (c) of impurity atoms (d) none of the above 53. In a JFET, when drain voltage is equal to pinch-off voltage, the depletion layers ....... (a) almost touch each other (b) have large gap (c) have moderate gap (d) none of the above 54. In a JFET, IDSS is known as .............. (a) drain to source current (b) drain to source current with gate shorted (c) drain to source current with gate open (d) none of the above 55. The two important advantages of a JFET are .............. (a) high input impedance and square-law property (b) inexpensive and high output impedance (c) low input impedance and high output impedance (d) none of the above 56. .............. has the lowest noise-level. (a) triode (b) ordinary transistor (c) tetrode (d) JFET 57. A MOSFET is sometimes called ....... JFET. (a) many gate (b) open gate (c) insulated gate (d) shorted gate…
    Tags: jfet, voltage, drain, input, gate, source, electronics, engineering
  • FET - 63FET » Exercise - 263. The gate voltage in a JFET at which drain current becomes zero is called .............. voltage. (a) saturation (b) pinch-off (c) active (d) cut-off
    Tags: fet, voltage, gate, jfet, drain, current, electronics, engineering
  • FET - 34FET » Exercise - 134. The JFET acts as a …….. along the horizontal part of the drain curve. (a) Resistor (b) Current source (c) Voltage source (d) Current sink
    Tags: current, fet, source, jfet, drain, voltage, electronics, engineering
  • FET - 1FET » Exercise - 1 1. The JFET acts as a ........... along vertical parts of the drain curve. (a) Resistor (b) Current source (c) Voltage source (d) Current sink
    Tags: fet, current, source, jfet, drain, voltage, electronics, engineering